You can add a back panel to the cabinet or create a custom back panel as needed. The operations are as follows:
Method 1: Right-click on the cabinet, Add function part (G) - Open the material table, select Backpanel - Wooden back plate and drag it to the cabinet (the software will automatically recognize and stick it to the back of the cabinet)

Method 2: Install the back panel - Select the corresponding back panel gap - Click Confirm to confirm the installation

 

 

Method 3: Create a custom back panel:
1. Press the B key to enter the panel detail mode;

2. 2. Press and hold the Ctrl key, and left-click on the four panels (top panel, bottom panel, left panel, right panel);
   3. Right-click on the panels that have been clicked with the mouse, select Generate - back panel generation.

The back plate generation process can be set independently (Note: The process created by method 2 and 3 can be set):
Adjust the back plate parameter table or replace the back plate type in the parameter floating table.