The cabinet body can be quickly beveled in the up-down, left-right and front-back directions by directly modifying the parameters or using the cabinet bevel function, which allows avoiding beams and columns in multiple directions for a cabinet. Please follow the operation steps below: (Note: This function applies to all custom cabinets from version 4.0 and above)
1. Take the custom cabinet as an example, right-click on the cabinet and right-click to enter the Angle cutting/ bevel cutting – Cabinet Chamfer settings

2. Left-click on the corner point to be beveled with the mouse. After selecting, the point will turn dark blue. Second, set the width and depth of the cabinet bevel according to the needs. For example, set the cabinet width to 250 and the depth to 100; (Note: The picture shows the width and depth of the chamfer)

3. After setting the chamfer, you can set the "thickness of the board" according to your needs. For example, set its thickness to 25. The patch method supports both the outside and inside;

4. If you do not need this "cabinet chamfer", you can left-click "Delete chamfer".

5. The operation steps for chamfering to avoid beams are the same. Select the points to be chamfered to edit (Through the cabinet chamfer function, you can set both column avoidance and beam avoidance for the cabinet at the same time).